25 M Na2SO3 and 0 35 M Na2S were added into the reaction cell Th

25 M Na2SO3 and 0.35 M Na2S were added into the reaction cell. Then, these photocatalysts were directly placed into the electrolyte solution. The whole system was vacuumized with a vacuum pump before reaction to remove the dissolved air. The temperature for all photocatalytic reactions was kept at about 20°C. Results and discussions The surface morphologies of the obtained Cd1−x Zn x S are shown in Figure 1. Figure 1a is the scanning electron microscopy (SEM) image of CdS; it presents porous flower-like 3D structure clearly, shorter nanowires appear at the periphery. As the value of

x increases, nanosheet emerges gradually, see more that is, the secondary structure builds up slowly. Figure 2 shows the XRD patterns of the as-prepared photocatalysts. CdS exhibits a Greenockite structure, while ZnS presents a Wurtzite polycrystalline structure, respectively. The diffraction peaks of the photocatalysts shift to a higher angle side as the value of x increases. The successive shift of the

XRD patterns means that the crystals obtained are Cd1−x Zn x S solid solution, not a simple mixture of ZnS and CdS [26]. Figure 1 Typical SEM images of the obtained Cd 1− x Zn x S photocatalysts. (a) Cd0.98S, (b) Cd0.9Zn0.1S, (c) Cd0.72Zn0.26S, and (d) Cd0.24Zn0.75S. Figure 2 XRD patterns of the as-prepared Cd 1− x Zn x S photocatalysts with different x values. (curve a) Cd0.98S, (curve b) Cd0.9Zn0.1S, (curve c) Cd0.72Zn0.26S, (curve d) Cd0.24Zn0.75S, and (curve e) Zn0.96S. The surface information is collected by XPS of the sample click here Cd0.72Zn0.26S (Figure 3). The survey scan spectrum (Figure 3a) indicates the existence of Cd, Zn, and S in the Cd0.72Zn0.26S sample. The two sharp peaks (Figure 3b) located at 404.3 and 411.2 eV are corresponding to the Cd 3d5/2 and Cd 3d3/2 level, respectively. The peaks of 1,020.8 and 1,043.7 eV can be assigned to the Zn 2p3/2 and 2p1/2 levels, respectively (Figure 3c). The single S 2p peak at 161.1 eV (Figure 3d) demonstrates that sulfur exists as a sulfur ion. Figure 3 Representative XPS spectra of typical sample Cd 0.72

Zn 0.26 S. (a) survey spectrum, (b) Cd 3d XPS spectrum, (c) Zn 2p XPS spectrum, and (d) S 2p XPS spectrum. Raman scattering is a nondestructive technique for structural study of the material selleck chemicals llc and a powerful probe to obtain the vibrational states of a solid. It is an inelastic process in which incoming photons exchange energy with the crystal vibrational mode. Figure 4 reveals the Raman spectrum of the as-obtained Cd0.72Zn0.26S sample. Bulk CdS has two characteristics of longitudinal-optical (LO) selleck kinase inhibitor phonon peaks: (1) 1-LO (first harmonic (at 300/cm)) and (2) 2-LO (second harmonic (at 600/cm)) vibrations [27]. The two phonon peaks are also observed in the as-obtained Cd0.72Zn0.26S; they are located at 306.5 and 608.1/cm, respectively, and shift toward the higher energy side compared with that of the pure CdS.

This entry was posted in Antibody. Bookmark the permalink.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>