In this study, we prepared different shapes of gold GDC-0973 price nanoparticles by seed-mediated growth method to apply on the photoelectrodes
of the DSSCs. The gold nanoparticles and DSSCs were investigated by field emission scanning electron microscopy (FE-SEM), ultraviolet–visible selleck chemical (UV–vis) absorption spectra, current–voltage characteristics, electrochemical impedance spectroscopy (EIS), and incident photon conversion efficiency (IPCE) analyses to study the SPR effect of the gold nanoparticles on the photoelectrodes of the dye-sensitized solar cells. Methods Chemicals Hydrogen tetrachloroaurate(III) trihydrate (HAuCl4‧3H2O, 99.9%), hexadecyltrimethylammonium bromide (CTAB), silver nitrate (AgNO3, 99.8%), ascorbic acid (AA, 99.7%), sodium borohydride (NaBH4, 99.9%) were used as reactants. TiO2 powder and 4-tert-butylpyridine were used as preparation paste of the photoelectrodes. The deionized (DI) water that was used throughout the experiments was purified using a Milli-Q system
(Millipore Co., Billerica, MA, USA). Glassware was cleaned by soaking it in aqua regia and then washing it with DI water. Synthesis of gold nanoparticles We used seed-mediated growth method to prepare the gold nanoparticles. This method involves two main steps: (1) preparation of seed solution, where the gold seed solution was prepared by first combining (5 mL, 0.5 mM) and CTAB (5 mL, 0.2 M), followed by the addition of freshly made NaBH4 (0.6 mL, 0.01 M) under vigorous stirring. Then, the mixture was left undisturbed, aged for 2 h at 25°C for further use. (2) The CHIR-99021 datasheet other is the preparation of a growth solution that consists of HAuCl4‧3H2O (5 mL, 1 mM), 0.2 mL AgNO3 (spherical and short and long rods are 0.01
and 0.04 M, respectively), and CTAB (5 mL, 0.2 M). AA (70 μL, 0.0788 M) was then added and followed by brief stirring (approximately 1 min). Finally, the spherical gold nanoparticles were synthesized, every 10 s, a drop for the short gold nanorods (aspect ratio of about HSP90 2.5), and every 1 min, a drop for the long gold nanorods (aspect ratio of about 4). Lastly, 25 μL of the seed solution was added to the growth solution. The mixture was allowed to react at 30°C. Centrifugation of the gold nanoparticles was carried out at 4,000 rpm for 20 min, and the supernatant was removed and then suspended with the same volume of deionized water. This process was repeated three times. Assembling the DSSC We used the scraper method to prepare the photoelectrode on fluorine-doped tin oxide glass substrate. The TiO2 coatings were prepared from commercial TiO2 particles (P25). The compositions of the TiO2 paste were TiO2, 4-tert-butylpyridine, and deionized water. The concentration of the TiO2 paste was 10 wt.%. The concentration of the gold nanoparticles added in the TiO2 paste is about 1.5 wt.%.