A further study compared results with one and two punches of buccal and blood FTA® card in 25 μl, 12.5 μl, and 6.25 μl reaction volumes. Samples were detected using Applied Biosystems® 3130 Series Genetic Analyzers with a 3 kV 5 s injection. Full
profiles were generated for all extracted DNA and swab lysates at 25 μl, 12.5 μl, and 6.25 μl reaction volumes (Fig. 5). Little variability was observed. Extracted DNA and swab lysates are homogenous and therefore sampling did not contribute to variability. Successful amplification was achieved using one buccal FTA® card punch in 25 μl see more and 12.5 μl reaction volumes (Fig. 5). Over 90% of the alleles were called at volumes 12.5 μl and greater. Reaction volumes of 6.25 μl showed a significant decrease in allele calls and ZVADFMK a sharp rise in reaction
failures. Sampling variability was observed with this substrate. In a more comprehensive examination of FTA® card samples, successful amplification was observed in 12.5 μl reactions using one blood FTA® card punch. Two punches from either buccal or blood FTA® cards in 12.5 μl reactions regularly allowed successful amplification; however, allele drop out and amplification failures increased compared to reactions using one punch (Supplemental Fig. 10). With 6.25 μl reaction volumes less than 50% of the expected alleles were called with one or two punches of buccal or blood FTA® cards. Amplification was unreliable and several complete failures were seen. Figure options Download full-size image Download high-quality image (140 K) Download as PowerPoint slide In initial testing PunchSolution™-treated nonFTA punches demonstrated a clear reduction in percent alleles called in 12.5 μl reactions, and no amplification Etoposide was observed with 6.25 μl reaction volumes. The lytic chemicals in the PunchSolution™ Reagent presumably overwhelmed the reactions with significantly reduced reaction volumes. Further testing was performed with AmpSolution™ Reagent to improve amplification of nonFTA punches in reduced volume reactions. PunchSolution™-treated nonFTA punches were amplified
in the presence and absence of AmpSolution™ Reagent at a reaction volume of 25 μl, 12.5 μl, or 6.25 μl. The percentage of alleles called was significantly increased at 12.5 μl and 6.25 μl reaction volumes in the presence of AmpSolution™ Reagent compared to reactions amplified without AmpSolution™ Reagent (Fig. 6). The amount of amplifiable DNA on solid support materials can vary widely, and therefore results can benefit from cycle number optimization. Three sites examined extracted DNA, FTA® card punches, or nonFTA punches from their own collections with varying cycle numbers. Extracted DNA was evaluated using 29, 30, and 31 cycles; FTA® card punches using 26, 27, and 28 cycles; and nonFTA punches using 25, 26, and 27 cycles.